Computer keyboard becomes dirty very easily when they do not care. In this guide will show you how to clean your keyboard, some simple household items. Your keyboard will look as good as new after.Here is what you need.
Tissue
The dust
Vacuum cleaner
Screwdriver
Toothpicks.
Cup water (optional). Q - tips (optional).
1, first turn off the computer and unplug the keyboard, remember that you Unplugged the keyboard from the socket, so you can plug into this, I suggest you find an open space use; One that is not crowded.
2 I took a picture of a keyboard or write down the address. You will need this as a reference on the back button on the keyboard if you have a Memory?
3 with the area of the keyboard on a flat surface. Open and use a vacuum attachment to the surface of the keyboard, trying to suck any loose material. I suggest using a brush attachment on the end, it will be very effective when trying to get into all cracks.
4 Shutoff a vacuum cleaner and get ready to start allover pad dust, the keyboard and try to get the keys and cracks slightly. Unless your keyboard has been sitting in the attic for years, you should not get too much dust.
5 Next to suck again, and run through the keyboard. Try your best to get the brush in the cracks of all to solve any of the material.
6 section for fun. Use a screwdriver and started one of the corners. (I recommend you start with the CTRL.) Insert the tip of the screwdriver and the screwdriver, the key should pop right off if you have done correctly. The key in a safe place so you do not get lost at the end of this booklet. I suggest you take a big key: Shift, spacebar, Enter and Backspace, unless you know what you're doing. These keys are hard to put it back when they were removed due to a small metal bar at the bottom of them. If you know what you do, go right ahead and pop them all off.
7 I have just about all of this started with the F key and the right side of the keyboard.
8 I'm out just about all the keys and a complete mess crumbs, hairs and dust, I have decided to close the large as well.
9 At this point you should just delete all the keys on your keyboard, unless you decide to a large button. I'm sure by now you pretty surprised at how much dirt is on your keyboard. The last time I cleaned it I found staples, paper clips and paper tabs. But because I had not cleaned up over the years.
10, again using a vacuum cleaner and suck out everything you can on the keyboard. You may have noticed a lot of it will stick and the vacuum will suck up. Again, I recommend using a brush attachment on the end. Back and forth in between the keys and the brush should loosen up a lot of material.
11, you will notice that your keyboard is starting to become dust. Now take a toothpick and try to get all the gunk that stuck around the edges. Use tissue to wipe off the tip of a toothpick. You may want to try q - tip at one end of the q tip and dip it in a cup of water. Trying to squeeze the tip q tip - so it is just damp and not dripping wet from q tip - with the keyboard, while the use of force to try and pick everything up, I flip the q tip - over and used the dry run. dried up along with what may be a bit wet.
Careful water use. If you get the keyboard all wet, it may not work correctly.
12 right now on your keyboard should be pretty clean. Make sure you dry off any parts that may still be wet.
Key 13 If you happen to be dirty, you can put them in a cup of water. I decided to put only a few keys in the water because they are very dirty and I want to get a lot of inches of oil to stop them. Swish the water around and try and scrape it clean. When you do this, remove the key from the water and dry. Make sure they are dry before you put it back on the keyboard.
14 Now, when your photo to come into action. Start putting all the keys in the proper position of All you have to do is the main line to the hole and press down and it should pop right back.
15 voila! And there you have it if you want you can run the vacuum over again to absorb what is left. If you want to keep your keyboard clean with a cloth to clean the surface rights, and you should have your keyboard clean.
